Panel assembly Positive terminal of the DC cord Antenna hot pin 3. IC generates the voltage to control IC and stabilizes transmission output. This applies to all parts: Holes Display PCB 5. In the RF section, use a 0.
|Date Added:||19 December 2014|
|File Size:||13.56 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
This feature is included in the FPU. The first IF is If the state of one of the ports changes, the MCU assumes that the key at the matrix point corresponding to that port has been pressed.
Connecting the Positive lead to any other positive 53y source in the vehicle is not recommended.
When the Wide port is high, the ceramic filter switch diodes D, D cause CF to turn on to receive a Wide signal.
RX high 2 SSG output: Confirm the VCO lock voltage approximately 3 seconds after the adjustment value is changed. To remove the speaker holder, first remove the two screws from the display PCB using a phillips screwdriver.
Squelch open 5 Wide 1 CH: When the Narrow port is high, the ceramic filter switch diodes D, D cause CF to turn on to receive a Kcg signal. When data is receiving by the transceiver, the green LED blinks. 53y the KCT Connection cable in the transceiver 1. Then, fit the panel assembly into the two tabs of the chassis bottom side by turning the panel assembly.
Pull it out behind the chassis by rotating the bush e of the DC cord 90 degrees in the direction of the arrow after the screw q in the negative terminal is removed, and the positive terminal w is removed from the chassis.
If the part number is not known, include the chassis or kit number of which it is a mct and a sufficient description of the required component for proper identification. Make sure sufficient air can flow around the radio and power supply to allow adequate cooling. Power on the target transceiver.
D.E.I.S Radio Telecomm. Ltd – Kenwood Analogue PMR Mobile TK
Clone Mode Programming data can be transferred from one transceiver to another by connecting them via their modular microphone jacks.
Receiver System Item The receiver is a double conversion superheterodyne. The amplified signal goes to the RF power module IC through a low-pass filter. The antenna system selection depends on many factors and is beyond the scope of this manual.
Programming Leads • KCTU Specifications • Kenwood Comms
E to the modular microphone jacks on the source and target. Flow chart Source transceiver Teile ohne Parts No.
HK2 7 Instruction manual B D, D, D to eliminate unwanted signals before it is passed to the first mixer. Check the vehicle ground polarity before installation to prevent wasted time and effort.
Kenwood TK-3302 Service Manual Page 4
The first local oscillator signal is supplied from the PLL circuit. When the 9TC signal goes low, no voltage is applied to 9T, and no signal is transmitted. The MCU then processes the decoded information.
Q turns on and a voltage is applied to the collector 9R. TX center 2 Transmit Frequency counter 2. These parts must be ordered separately.
Remove the speaker-jack cap on the rear of the transceiver. Q turns on and a voltage is applied to 9T. The ignition function lets you turn the 53h to the transceiver on and off with the car ignition key.
IC generates the voltage to control IC and stabilizes transmission output.